Hall-effect Sensor - US1881
Description:
The US1881 is an integrated hall effect latched sensor. That’s nice but what does it do? Holding a magnet near the sensor will cause the output pin to toggle. This makes for a robust presence sensor. A reed sensor also works nicely, but can be limited by the glass encapsulation and size. A hall effect sensor is much smaller, but can handle less current than a reed switch.
The device includes an on-chip Hall voltage generator for magnetic sensing, a comparator that amplifies the Hall voltage, and a Schmitt trigger to provide switching hysteresis for noise rejection, and open-collector output. An internal bandgap regulator is used to provide temperature compensated supply voltage for internal circuits and allows a wide operating supply range.
If a magnetic flux density larger than threshold Bop, DO is turned on (low). The output state is held until a magnetic flux density reversal falls below Brp causing DO to be turned off (high).
Features:
* 3.5V to 24V DC operation voltage
* Low current consumption
* Temperature compensation
* Wide operating voltage range
* Open-Collector pre-driver
* 50mA maximum sinking output current
* Reverse polarity protection
* Lead Free Package: TO-92 （UA Package)
Click for DataSheet
Hooking it up:
Pin Function
1 VDD
2 GND
3 OUT
